5. Remove bumper:
Remove bumper (7) bolts (M13 socket and socket
extension), lift up as needed to remove bumper. Remove and save for
reinstallation.
6. Optional - Bolts for support:
Run (1) bolt (item 1) through the existing weld
nut from forward side of end panel. Use bolt for ease of installation. Both sides.
See figure 4.
4b. Remove rear fascia:
Carefully pulling the fascia away from the vehicle. Use care at lower part of wheel well there are (2) fixed pins
(see figure 3a)
, carefully work
fascia over pins. If present disconnect any wiring harness or sensor from fascia. Both sides. Note: Use trim tool or screwdriver near corner – tight fit. See figure 3.
Figure 3
Figure 4
Figure 3a
