Centurion RDO-10A, Инструкция по установке и руководство пользователя, Страница: 8 / 12

8
Function
Constantly monitors the spring balance of the garage door
and warns the user when door is out of balance. Courtesy
lamp will triple blink every 15 sec once imbalance is
excessive. At this time the garage door should be serviced
by a suitably qualified technician.
To Enable

Select Dip 4 to the “ON” position
Function
The LED (13 ‐ I) provides Opener status information.
Indication

Glow Solid – Opener has reached close limit position

Slow Blink – Opener has reached open limit position

Rapid Blink – Opener Learning new drive force values

Intermittent Blink – Sleep Mode
Function
Safety Beams constantly monitor for persons or objects
which may cross the path of a moving garage door. The
Opener will commence to Safety Reverse when the Safety
Beams become momentarily or permanently interrupted
during a closing movement. The Opener will support the
connection of 2 or 4 wire Safety Beams.
Fault Indication
Courtesy Lights will double blink and the Opener will not
move if the Safety Beams are faulty or misaligned.
Override

Press and hold the Run Button (Fig.6A or 7 ‐ A) until the
Opener has reached the fully closed position
To Enable

Select Dip 2 to the “ON” position (Fig.7 ‐ G)
Connection

2 Wire Beams – Select jumper (Fig.7 ‐ H) to “1 ‐ 2” position
and connect the wires as per Fig.8 ‐ A

4 Wire Beams – Select jumper (Fig.7 ‐ H) to “2 ‐ 3” position
and connect wires as per Fig.8 ‐ B
Function
Allows speed adjustment of the Opener to best suit the
door type. (Only available in A Mode)
Adjustment

Stop Opener midway between open and close position.

Press and hold Learn Button (Fig.6 ‐ A or 7 ‐ A) until LED
(Fig.7 ‐ I) begins to rapid blink.

Rotate the Speed Adjust Pin (Fig.7 ‐ D) while opener is
running ‐ clockwise to increase speed and anti clockwise
to decrease speed.

Speed may only be adjusted while the Opener is traveling
between limits.

Adjustment function will close out automatically once
either one of the limits has been reached
Function
The following accessories may be connected;
a. 2 wire Safety Beams (Fig.8 ‐ A)
b. N.O. 24V DC 4 wire Safety Beams (Fig.8 ‐ B)
c. 24V DC universal receiver (Fig.8 ‐ C)
d. N.O. momentary (dry) contact wall switch (Fig.8 ‐ D)
e. 240V relay driven courtesy light – output 24VDC, 150mA
maximum (Fig.7 ‐ J)
Function
Disables push button functionality in order to provide
utmost security whilst user is absent for extended periods
of time
To Enable

Press button 4 of Mass Learned transmitter

Courtesy Light 4 x blink to indicate Opener has entered
Vacation Mode
To Disable

Momentarily press either button 1 or button 2 of a Mass
Learned transmitter
19. Safety Beams
20. Speed Control
21. Terminal Connections
22. Vacation Mode
18. LED Indicator
SETTINGS AND ADJUSTMENTS
17. Door Service monitor