8. Electrical setup
1. Ensure that all low voltage systems (less than 42.4V) are
suitably protected from damage, by disconnecting all
sources of power such as chargers and batteries before
doing any work.
2. All electrical work must be carried out according to the
requirements of all applicable local electrical codes.(It is
recommended that a licensed electrical contractor perform
such work.)
roadside to accommodate the feeder. After the loop and feeder
wires have been placed in the slot, the slot must be filled with an
epoxy compound or bitumen filler.
7. Mounting instructions
The housing of the
FLUX 11
is not weatherproof, and it should not be
mounted externally.
Simply insert the
FLUX 11
into the 11 pin base of the access
control device.
Lead cable
slot
Corner stress
relief
4mm Saw slot
Pavement surface
50mm
4mm
Saw cut
11
1
2
3
4
5
6
7
8
9
10
Loop detector base
Presence
relay
output
Presence
relay
output
Power
input
Free-exit
loop
FLUX 11
loop detector
Plug the FLUX 11 into the base
