Centurion Fi21, Руководство пользователя

Страница: 185 / 194

Section 13
13-2
Poor boat performance
• Contaminated fuel
• Uneven load distribution
• Excessive load
• Improper trim equipment position (if
equipped)
• Improper propeller selection
• Excessive water in bilge
• Damaged or obstructed propeller
• Marine growth on hull
• Damaged hull
• Engine system problem
• Plugged flame arrestor (if equipped)
Throttle/shifting control
problems
• Corroded cable
• Excessive bends or kinks in cable
• Engine system problem
Excessive vibration
• Damaged or obstructed propeller
• Bent propeller shaft
• Engine system problem
Electrical problems
• Blown fuse/breaker or open circuit
• Loose or corroded wiring connections
• Defective switch or gauge
• Weak or discharged battery
Ramfill tanks do not seem to be
filling up, or they are full on the
screen but you're listed to one
side or another
• Check the “fill” valves to see if they are
opening up while under way. If they are
not opening up then you will not have
water entering the ballast liner.
• Check the valves in the back of the boat
where the Ramfill drains are located. Are
the handles all the way up? If so they are
in the open position. This means when
you're underway the water is rushing out
of the tank (instead of staying inside the
ballast liner). If this is the case push the
valve back down (make sure the clip is
secured in place), then “Override” the fill
for Ramfill on the Touch Vision display
screen until you see water coming out
the vent. See Figure 13-1.
Problem Possible Causes