Centrosolar CENPAC 3 Series, Инструкция по монтажу

Страница: 14 / 24

14
12 - Positioning the module support
The module support profiles are mounted from
below (the eaves) starting towards the ridge.
The overhang of the module support profiles
may not exceed the outer 2-C groove profiles
by over 400 mm.
The connections of the 2-C groove profiles
are
established with the module support profiles via
clamping jaws . The profile protective covers ,
that were mounted in the 2-C groove profile in
the previous stage are for positioning the mod-
ule support profiles.
13a - Positioning the clamping jaw
Guide the clamping jaw from above into the
groove of the 2-C groove profile . The hammer
head screw is fixed in the 2-C groove profile
with a rotation of 90° .
13b - Mounting the clamping jaw
Before fastening the hexagon bolt, position the
clamping jaw so as to maintain a distance of ca.
2 mm between the angle stub of the protective
cover and the rear end of the fixed clamp.
The front part of the fixed clamps is on the
toothed part of the module support up to the
stop.
The nuts on the hammer head screws M10
(clamping jaws) should be tightened with a
torque of 50 Nm.
ca. 2 mm