Centro Barbecue Stainless 4000B Safe use, Инструкция по безопасному использованию, уходу и сборке

Страница: 7 / 24

5
L I G H T I N G
T H E G R I L L
•
Make sure you have followed all the checks, procedures and instructions
indicated in the prior sections before attempting to light the grill.
•
Always raise the barbecue lid before lighting the burner.
•
Do not bend directly over the barbecue while lighting in case of back flash.
•
Making sure all the control knobs are off, slowly and carefully open the propane gas
cylinder valve. Wait about five seconds before opening the burner valve and lighting
the barbecue. This procedure allows the pressure to stabilize, and prevents the
flow control feature from activating. Note: If the flow control feature does activate,
turn off the burner control valve and the cylinder valve, wait about 30 seconds then
turn on the cylinder valve slowly. Wait 5 seconds and turn on the burner valve and
light the barbecue.
Lighting the Main Burner
•
Important: Light centre burner / burners first !
•
Once burner is lit the burner next to it will light by turning the control knob to “HIGH”.
•
Never light the outside burners unless the centre burner / burners are lit.
Using the Igniter to Light the Burner
•
Raise the lid of the barbecue.
•
Turn on tank.
•
Push in and turn the control knob to “HIGH” position.
•
Push the igniter button until a clicking noise is heard (a spark is being applied).
•
If the burner does not light after three attempts, turn the control knob
to the “OFF” position and wait for the gas to clear (about 5 minutes).
Repeat the previous lighting procedure.
•
If the burner still does not light, refer to the troubleshooting guide for help,
or light with a long match with extension match holder provided.
Manual Lighting Procedure
The barbecue has a small hole on the lower left side of the housing. This hole is towards
the front of the barbecue and is used to manually light the barbecue.
•
Raise the lid of the barbecue.
•
Place the lighted match with a match holder, or extension rod provided,
through the hole to within 1.6cm (1/2”) of the burner.
•
Turn on tank.
•
Push in and turn the burner knob to the “HIGH” position. At this point,
the burner should light, if it doesn’t after 5 seconds, turn the control knob
back to the “OFF” position and wait for the gas to clear.
•
Wait 5 minutes, and then repeat the manual light procedure. If after three tries the
burner still does not light, review the troubleshooting guide for help.
To Reset the Gas Regulator Safety Device
•
Close the LP (propane) tank valve.
•
Turn all burner control knobs to the “OFF” position.
•
Disconnect the regulator from the LP tank.
•
Open grill lid. Wait five minutes for gas to clear.
•
Re-connect the regulator to the LP tank. Test for leaks.
•
With lid open, turn the centre burner control knob to the “HIGH”
position and then ignite the grill by pushing the igniter button.
•
Close the grill lid.
•
Wait for 10 to 15 minutes. The barbecue should become hot.