Centro 85-1003-8, Инструкция по безопасному использованию, уходу и сборке

Страница: 19 / 24

1 7
Parts Included With Your Grill
This model comes equipped with a 12’ Natural Gas hose with male socket connection that
will allow you to attach your Barbecue to your residential gas line.
Before lighting your Barbecue for the first time, and at the beginning of every season you
must do the following:
Warning: We strongly recommend contacting a certified gas-technician to install your nat-
ural gas grill.
To Connect
1. Push back the sleeve on the socket as shown in figure
2. Insert Plug and release the sleeve as shown in figure
3. Push the plug until the sleeve snaps forward, to lock the plug in the socket.
To Disconnect
1. Push sleeve back and pull the plug out.
Testing For Gas Leaks
Before attempting to operate this Grill:
1. Always confirm that all burner control knobs are in the OFF position.
2. Always connect the gas supply hose first and then open the gas shutoff valve.
3. Always use a brush or spray bottle to apply a 50/50 solution
of liquid soap and water to all connection points, to test for
gas leaks. Never use a match or open flame for that purpose.
4. Always look for bubbles to appear, as the appearance of bubbles
will indicate a gas leak. Always turn off the gas immediately
and tighten the connection, if you find that a leak exists.
5. Always repeat this procedure until no further gas
leaks are found to exist, before lighting the grill.
6. If a leak cannot be stopped, do not attempt to light the grill.
Always contact Centro Customer Support for assistance. 1-888-707-5463.
Gas Hookup & Warnings
Warnings: Poor Natural Gas Burning Performance and heat distribution is related to the
points listed below..
Always consult the Rating Label on the back of the Grill to confirm that it has already been
configured to burn natural gas.
All gas supply plumbing must be carried out by a qualified service agency. The Supply con-
nection shall be carried out in accordance with provincial authorities having juridiction, and
in accordance with CAN/CGA 1-B149.1 & 2 installation code requirements. A shut off
valve must be installed between the gas grill and the main supply. For natural gas, use a
3/8” or _” natural gas supply line capable of an input of upto 75,000 BTU’s (depending on
the model).
N A T U R A L G A S M O D E L
8 5 - 1 0 0 3 - 8 ( G 4 1 3 0 4 )
W A R N I N G
Do not attempt to use a longer natural gas hose than the one supplied
with your grill, as poor burner performance will be the result.
Attach the Natural Gas Hose (included with
your barbecue) to the grill. Tighten the female nut of
the hose onto the side burner valve using a wrench.