Centre Point 400110, Инструкция по эксплуатации

Страница: 6 / 16

FIGURE 4
FIGURE 5
FIGURE 6
6
SETUP
•
Select a place as close as practical
to the work site. Ensure the location
is clear of traffic.
•
Place the laser on a level surface
such as a bench or supplied mount.
OPERATION
Powering on (self-levelling)
•
To turn the instrument on, slide the power
/ locking switch to the “unlocked” position
(Fig.4). Self levelling will commence and the
horizontal beam will activate (Fig.5).
•
Press the line mode button on the control
panel to cycle through the active beams (Fig.6).
•
If the instrument is outside the self levelling
range the instrument will not level causing the
laser beam to flash on and off repeatedly. If this
occurs, reposition the instrument onto a level
surface until the instrument can level off.
Powering off (self-levelling)
•
To turn the instrument off, slide the power
/ locking switch to the “locked” position.
Tilt lock function (manual mode)
•
Ensure the power / locking
switch is in the “locked” position.
•
Press and hold the line mode button for
3 seconds. The horizontal line will activate.
•
The instrument can now be
tilted to the desired angle.
•
Press the line mode button on the control
panel to cycle through the active beams.
•
To turn off the beams, press the line
mode button until all beams are off.
When in tilt lock function (manual mode)
the instrument will not self level and
correct for vibrations and/or disturbances.
Active laser beams will flash every four
seconds when in manual mode.
Using the Laser (continued)
LINE PULSE