NOTICE
Clean the Airbrush IMMEDIATELY after use.
Delayed or inadequate cleaning will permanently clog the Airbrush.
Page 14
For technical questions, please call 1-888-866-5797.
Item 95923
S
AFETY
Op
E
r
A
TIO
n
M
AI
n
TE
n
A
n
CE
S
ET
up
Cleaning
TO prEVEnT InJurY:
needles are very sharp. use extreme caution when handling needles.
Solvent Selection
Follow the paint manufacturer’s
recommendations for cleaning, solvent type,
and disposing of used solvent.
WArnInG! TO prEVEnT FIrE,
IF A FLAMMABLE SOLVEnT
nEEDS TO BE uSED,
ADHErE TO THE FOLLOWInG:
a.
Follow solvent manufacturer’s clean up
instructions and safety precautions.
b.
Flush Airbrush a full hose
length from air compressor.
c.
If collecting flushed solvents in
metal container, transfer to nonmetal
container, and flush metal container.
d.
Work far away from any ignition
sources in a vapor free area.
e.
Keep class ABC fire
extinguisher nearby.
After each use:
1. Empty the Jar and clean it with the solvent.
2. Fill the Jar with solvent and spray it
through the Airbrush into a container.
Once the Jar is empty, repeat the process
until the solvent comes out clean.
1. Disconnect from the air source.
2. After disconnecting, point the Airbrush into
the spent solvent container and depress the
Trigger again to make sure no air remains.
3. Remove the Nozzle and Needle
and soak them in solvent until
clean. Use old toothbrush and
toothpicks to remove any paint.
nOTICE:
Do not immerse Airbrush.
note:
Do not use metal objects to clean the
nozzle to prevent damage to the passages.
4. Inspect Needle. If it is bent, have it
replaced by a qualified technician.
5. Use appropriate solvent to wipe
down Airbrush body.
6. Lubricate Airbrush after cleaning.
A non-silicon oil or a light lubricant may be
used on threaded connections before storing.
Solution Disposal
After cleaning, dispose of cleaning solution
according to the solution manufacturer’s
directions and local hazardous waste standards.
