© 2018 Centralite. All rights reserved.
Data Sheet: 3-Series Motion Detector (3305-G)
Page 2 of 3
Use Cases
Special Features
Getting Started
Troubleshooting
• Save energy by turning off lights in areas that
aren’t being used.
• Receive alerts if motion is detected while you’re
away.
• Create custom automatic flood light and entry
scenes.
• Use time-based motion triggers to light a path at
night.
Save energy by turning off lights in areas that
aren’t being used.
Energy is wasted any time lights are on in a room that
isn’t being used. By adding a 3-Series Motion Sensor
to the room, your home can automatically turn off
lights when there hasn’t been activity for more than
15 or 30 minutes.
Create custom automatic flood light and entry
scenes.
Install the 3-Series Motion Sensor near the front door
or garage to trigger “welcome” lighting scenes in
the home. Upon motion in a garage, the home can
automatically turn on garage, hallway, living room,
and outdoor flood lights.
Use time-based motion triggers to light a path at
night.
Combine the Motion Sensor with time-based rules to
automatically dim lights low at night. For a late night
trip to the kitchen or bathroom, the Motion Sensor
can trigger lights to fade up to only 20%, saving your
eyes from bright, harsh light.
Easy Mounting Options
The 3-Series Motion Sensor can be installed using
either adhesive strips or mounting screws (both
included). The easy-to-install mounting plate attaches
with a single screw and the sensor simply slides into
place on the mount.
Pull-to-Pair Join Process
All 3-Series sensors feature “pull-to-pair” joining. The
device ships with the battery pre-installed and all that
is needed to begin the joining process is to pull out
a small plastic tab from the bottom of the device.
There is nothing for the user to take apart or put back
together.
ZigBee Home Automation 1.2 Compatibility
The 3-Series Motion Sensor is fully ZigBee HA 1.2
certified and is guaranteed to function with all open,
ZigBee HA 1.2-certified hubs and devices.
Superior Range and Updatability
The 3-Series Motion Sensor includes a built-in power
amplifier, giving the module superior range and stability
in large homes or areas with wireless interference.
The Motion Sensor also supports over-the-air updates
providing for seamless upgrades and feature additions
without the need for any user interaction.
Step 1: Open ZigBee Network for Joining
Using your controller or hub’s interface, enable the
ZigBee network for joining.
Step 2: Pull Tab from Bottom of Sensor
Pull the small plastic tab out of the bottom of the
sensor and it will immediately begin searching for a
network to join.
Step 2: Finish Joining at Hub (optional)
Some hubs and controllers require additional steps
such as naming or categorizing the device.
Step 1: Remove and Replace Battery from Device
Remove cover from sensor. Remove battery and
replace with a new CR-2 battery. Reassemble and
test operation.
Step 2: Factory Reset and Rejoin
Remove cover from sensor and remove battery.
While holding down the reset button, reinsert battery
to factory reset the device. Repeat the “Getting
Started” steps to rejoin the ZigBee network.
