Page 12
For technical questions, please call 1-800-444-3353.
Item 98895
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
User-Maintenance Instructions
procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and
release the trigger before performing any inspection, maintenance, or cleaning procedures.
TO pREVENT SERIOUS INJURy FROM TOOL FAILURE: Do not use damaged equipment.
If abnormal noise, vibration, or leaking air occurs, have the problem corrected before further use.
TO pREVENT SEROUS INJURy FROM EXpLOSION:
Lubricate the tool only with specified lubricants. Lubricate the air inlet using only
pneumatic tool oil. Other lubricants may damage the mechanism and may be highly
flammable, causing an explosion.
cleaning, Maintenance, and Lubrication
Note:
These procedures are in addition to the regular checks and maintenance
explained as part of the regular operation of the air-operated tool.
1.
BEFORE EAcH USE,
inspect the general
condition of the tool. Check for:
• loose hardware or housing
• misalignment or binding of moving parts
• cracked or broken parts
• any other condition that may
affect its safe operation.
2.
Daily - Air Supply Maintenance:
Every day, maintain the air supply according
to the component manufacturers’ instructions.
Maintain the lubricator’s oil level.
Drain the moisture filter regularly.
Performing routine air supply maintenance
will allow the tool to operate more safely
and will also reduce wear on the tool.
3.
Weekly - Tool Maintenance:
Drop some pneumatic tool oil into the air
inlet of the tool and run the tool slowly
for a minute before beginning work.
Check the inner dust collection port
for sawdust buildup that would reduce
the dust collection efficiency:
a. Remove the Backing Pad (41) as described
in
Replacing the Backing Pad
below.
b. Inside the tool is the inner dust collection
port where sawdust may accumulate. Keep
this port opening clear using a toothpick
and clean up with an old toothbrush.
c. Replace and secure the Backing Pad.
4.
Quarterly (every 3 months) –
Tool Disassembly, cleaning, and Inspection:
Have the internal mechanism cleaned, inspected,
and lubricated by a qualified technician.
If the vanes need replacement,
replace them all as a set.
Replacing the Backing pad
1. Disconnect from air source.
2. Slide the Wrench (39) between the
Backing Pad (41) and the Flexible Rubber
Cover (37) and engage the Backing Pad
Retainer (28). Holding Wrench firmly, grasp
Backing Pad and unscrew from Sander.
3. Grasp Backing Pad Retainer firmly with
Wrench and firmly screw new Backing
Pad into Backing Pad Retainer.
Содержание 98895
Страница 1: ......
