Page 6
For technical questions, please call 1-888-866-5797.
Item 93012
SAFET
y
Op
ERA
TION
M
AINTENAN
c
E
SETU
p
Specifications
Motor
120 VAC, 60 Hz, 1.2 A
Switch
Toggle, On/Off, with removable locking key
Table Tilt
0 to 45 degrees (left)
Cutting Depth
2″ (maximum)
Blade Type
5″ L Pin End blade; Can use plain end blade with provided
adapters. 15 TPI blade mounted on machine
Throat Depth
16″
Blade Stroke
13/16″
Cutting Speed
400 (min.) to 1600 Strokes per Minute; Variable
Base Mounting Holes
4 - 5/16″ (dia.) holes
Accessories
2 - Hex Keys (2.5 and 4 mm); 2 - Plain end Blade Adapters;
1 - Spare 18 TPI Saw Blade
1 - Spare 15 TPI Saw Blade
Features
Drop foot adjustment, Integrated bellows air pump,
1-3/8″ OD Vacuum port
Setup - Before Use:
Read the ENTIRE IMpORTANT SAFETy INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO pREVENT SERIOUS INJURy FROM AccIDENTAL OpERATION:
Turn the power Switch of the tool off and unplug the tool from its electrical outlet
before performing any procedure in this section.
Note:
For additional information regarding the parts listed in the following pages,
refer to the Assembly Diagram near the end of this manual.
Assembly/Mounting
1. Pick a solid, wood workbench to mount the saw. The
workbench must be stable, and able to support the
weight of the Scroll Saw and the material being cut.
2. Find the four 5/16″ mounting holes in the Base (9)
and mark through the holes for drilling with a
3/8″ drill bit. Remove Scroll Saw to drill holes.
3. Replace Scroll Saw over holes and mount with the
following hardware (not supplied):
4 Bolts, 1/4″ x 20 length required;
4 Flat Washers, 9/32″ I.D.; 4 Lock Washers,
9/32″ I.D.; and 4 Nuts, 1/4 x 20.
4. Check that all Scroll Saw screws and nuts
are tight before using the machine.
check and Align Bevel Indicator
1. Loosen Table Lock Knob (44) and move the
table until it is approximately perpendicular
(right angle) to the blade. See Functions.
2. Use a small combination square to set
the table at 90 degrees to the blade.
3. Tighten the Table Lock Knob (44).
4. Loosen Pan Screw (14) holding the bevel
Scale Indicator (13), and adjust Indicator to
point to “0” degrees. Retighten Pan Screw.
Note:
The bevel Scale Indicator (13) is a guide
and should not be relied upon for precision
settings. Make practice cuts in scrap wood to
determine if the angle settings are correct.
207013
