Page 20
SKU 91815
2.
Raise the Blade Guard (10) to expose the Saw Blade. Place the stock to be cut next to
the Saw Blade and adjust the Saw Blade height to 1/8” to 1/4” above the thickness of
the stock.
3.
Lower the Blade Guard (10), making sure that the Anti-kickback Pawls are facing
backward and sitting on the Table.
4.
Place the Key Lock into the Switch (74) and press up to turn on the Table Saw.
Warning! Avoid serious injury. Keeps hands away from the moving Saw Blade.
5.
When the Saw Blade is turning at full speed, guide the side of the stock flush against
the Fence and level with the Table, then push forward into the Saw Blade at a slow
and even pace. Use a push stick (not supplied) to complete the cut as the end of the
stock approaches the Saw Blade.
6.
When the cut is complete, step back and press the Switch down to the Off position.
7.
When the Saw Blades stops turning, remove the stock from the Table.
Making a Cross Cut
1.
Loosen the Fence Lock Knob (56) and remove the Fence from the Table. Set the
Fence in a safe place away from the Table Saw.
2.
Place the Miter Gauge in the slot to the left or right of the Saw Blade.
Slide the Miter Gauge back and forth in the slot. If movement is sluggish, remove the
Miter Gauge and rub some hard wax into the entire slot. Replace the Miter Gauge and
slide it back and forth in the slot until movement is easy.
3.
If an angle is to be cut, adjust the Miter Gauge by loosening the Lock Knob (1) and
setting the desired angle as read on the scale. Retighten the Lock Knob.
4.
With the Miter Gauge in front of the Saw Blade, place the stock to be cut flush against
the Miter Gauge surface and align the cut mark with the Saw Blade.
5.
Raise the Blade Guard (10) to expose the Saw Blade. Place the stock to be cut next
to the Saw Blade and adjust the Saw Blade height to 1/8” to 1/4” above the thickness
of the stock.
6.
Lower the Blade Guard (10), making sure that the Anti-kickback Pawls are facing
backward and sitting on the Table.
7.
With the Key Lock in the Switch (74), press up to turn on the Table Saw.
8.
When the Saw Blade is turning at full speed, carefully push the Miter Gauge with one
hand and the stock to be cut with the other. Longer stock needs to have external
support at the same height as the Table.
Warning! Avoid serious injuries. Always keep both hands and arms on one side of the
Saw Blade, never cross over the Saw Blade.
9.
When the cut is complete, step back and press the Switch down to the Off position.
10.
When the Saw Blade stops turning, remove the stock from the Table.