Fig. 4. Aligning the Table
and adjusting the Scale
Page 8 SKU # 41889
ADJUSTING AND USING THE TABLE ALIGNMENT FEATURE
Aligning the Degree Scale Pointer
1.
Loosen the table lock knob and move the table until it is
approximately perpendicular, that is, at a right angle to
the blade.
2.
Place a small square on the table next to the blade as
shown in
Figure 4
to check if the table is 90
O
to the
blade. If adjustment is needed, raise or lower the table
until it is as close to 90
O
as possible. Securely tighten the
table lock knob.
3.
Loosen the screw holding the degree scale pointer, as
shown in
Figure 4
. Move the pointer to the 0
O
degree
marker on the scale, and securely tighten the screw.
Remember the scale is a convenient guide, but should not
be relied upon for extremely accurate cutting. Make
practice cuts in scrap wood to determine if your angle
settings are correct.
Setting the Table for Horizontal or Bevel Cutting.
1.
Loosen the table lock knob, and the saw table can be
tilted to the left and locked in any angle from 0
O
degree
horizontal cutting position up to 45
O
for bevel cutting.
2.
A degree scale is also provided under the work table as a
convenient reference for setting the approximate table
angle for bevel cutting. When greater precision is
required, make practice cuts and adjust the table as
necessary for your requirements.
3.
NOTE: When cutting at angles, the drop foot can be tilted
so it is parallel with the table surface, and rests flush
against the workpiece. To tilt drop foot, loosen the allen
screw, tilt the foot so it is parallel with the table, and then
securely retighten the screw.
Fig. 5. Adjusting the Table Angle
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS MANUAL AS
A R E F ER E NCE TOOL ONLY: NE IT HE R T HE MANUFAC T U RE R N O R D I S T RI B U TO R M A K ES A N Y
REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE
ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE
PRODUCT: IN FACT THE MANUFACTURER A ND/OR DISTRIBUTOR EXPRESSLY STATES THATALL REPAIRS
AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND
NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS
TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.
Brought to You by Augusta Flint