SKU 54877
For technical questions, please call 1-800-444-3353.
Page 8
Step 6: Place jack stands underneath vehicle at specified points. Refer to the vehicle’s
Owners Manual for proper jack stand placement locations.
Step 7: Slowly twist Handle Assembly counterclockwise. This will lower the vehicle onto
the jack stands.
WARNING:
Watch for movement of vehicle or jack stands as vehicle is lowered.
If any movement occurs, jack vehicle up and adjust jack stands properly.
Step 8: Completely lower the Floor Jack and remove from underneath the vehicle.
CAUTION:
When not in use, make sure pressure is released
by turning Handle Assembly fully counterclockwise.
This will prolong the life of the jack.
Step 9: To make sure vehicle is stable, stand away and attempt to rock the vehicle. If
movement is detected, jack up the vehicle and adjust jack stands properly. Test again.
Purging the air from the hydraulic system
and filling the floor jack with oil
NOTE: If the Floor Jack stops working it may be low on oil or there may be air
trapped in the hydraulic system.
Step 1: Turn the Handle 1-1/2 turns counterclockwise to lower the Floor Jack.
Step 2: Remove the FILL PLUG (#31A), shown on page 9 Figure # 5, It is located in the
gap between the Lift Arm Assembly (#30) and the Handle Socket. You can remove it
using a flat head screw driver.
Step 3: Rapidly pump the Handle Assembly several times to purge air from the hydraulic
system.
Step 4: Close the release valve by turning the Handle Assembly completely clockwise.
Step 5: Top off the pump with hydraulic oil if needed and replace the Oil Fill Plug.
