CentoLight ZEPHIRO FOG 3000, Руководство пользователя

Страница: 13 / 32

13 13
Zephiro Fog 3000 User Manual
Eng
2) Wireless remote control
Once warm-up process is complete, press A or B button to emit fog. By pressing
them long time, you can spray fog long time till the unit will warm up again. By re-
leasing buttons, it stops spraying fog.
3) DMX512 Control
One DMX Channel is used to control fog emission. This channel is selectable
through the DMX Dip-switch panel.
Switch value
Switch number
Final value is obtained by adding values of all switches in ON position. This way,
you are able to make combinations to reach the desired DMX value between 1 and
512. For example, if you wish to set the device to channel 33, you need to select dip-
switch 1 and 6 (1 + 32 = 33).
4) Wireless Remote Battery Replacement
If the remote control cannot work (red LED does not lit and machine does not oper-
ates), please check whether battery is low and need to be replaced.
To change the battery, remove the cover on the back of the remote control and
replace the old battery with one of the same type (23A - 12V).
ATTENTION: Pay attention to respect the polarity. The two ends of the battery
have a “+” (positive pole) and a “-” (negative pole) respectively. These marks are
also present inside the battery compartment. Make sure the “+” of the battery is
towards the “+” indicated in the battery compartment.
6 - C
orreCT
u
se and
M
aInTenanCe
This fog machine should be used in dry and well-ventilated place . Please avoid any
water or rain fall in the machines, if water and rain fall in, turn off the power immedi-
ately. Keep far away from children, fire, explosive and flammable things, and avoid
scalding.
NOTE: In the first time use, some liquid might spray out. This is normal.
y
When liquid is getting low, please add it again in time. If the fog machine works
without fluid for a long time, its pump and other parts could get damaged.