Centeron
®
Digital Two Channel Monitor Instruction Manual
Robertshaw Industrial Products
Page 11
§
Insert the new battery (observing polarity markings molded into the battery holder).
§
Carefully install a new tie wrap through the circuit board slots and secure it around
the battery.
Trim the tie wrap, leaving a minimum of ¼” untrimmed material.
§
Ensure that the upper housing O-ring is properly positioned on the lower housing O-
ring shelf.
§
Firmly reinstall the Monitor’s upper housing.
Note: The mounting screws are not evenly spaced around the upper housing in order to
insure that the housing will only fit in the proper orientation.
§
Using a Phillips screwdriver, gently tighten the 3 screws on the Gauge Monitor
housing to 10+/- 2 inch pounds. Do not over tighten.
§
Re-install the monitor on the tank.
§
Follow the battery manufacturers’ safety and disposal guidelines
5.2 Warranty
Seller warrants title and that products sold to Buyer shall be free from defects in material
and workmanship and shall conform to specifications for a period of one (1) year from
purchase for complete units and parts and subassemblies. Warranties on goods sold but
not manufactured by the seller are expressly limited to the terms of warranties of the
manufacturer of such goods.
Seller makes no representation or warranty of any kind, express or implied, as to
merchantability, fitness for particular purpose or any other matter. Upon receipt of
definite shipping instructions, Buyer shall return, transportation prepaid, all defective
material, or material not conforming to specifications, to Seller, after inspection by Seller,
or at Seller’s election, subject to inspection by Seller. Material returned by Buyer must
be returned in same condition as when received by Buyer. Defective material, or material
not conforming to specifications, so returned shall be replaced or repaired by Seller and
returned, freight prepaid, without any additional charge, or in lieu of such replacement or
repair, Seller, may, at Seller’s option, refund the purchase price applicable to such
material. Seller agrees to pay return freight charges not exceeding the lowest rail or truck
rate which would apply from the original destination on all defective material, or material
not meeting specifications. However, Seller shall not be obligated for such charges when
material returned proves to be free from defect and to meet specifications. Material that
proves to be free from defect and to meet specifications shall be held by Seller for
shipping instructions and Buyer shall furnish such instructions promptly upon request.
Seller’s liability shall be limited solely to the replacement or repair or to refunding the
