Page 6
For technical questions, please call 1-800-444-3353.
Item 69368
Specifications
Electrical Rating
120V~ / 60Hz / 9A
@ 40A, 12V Setting
Charge Settings
2A, 12V
10A, 12V
40A, 12V
Starter Settings
100A, 6V
60 second maximum with 90 second minimum rest
200A, 12V
5 second maximum with 240 second minimum rest
Battery Cables
6' 6"
Red = Positive
Black = Negative
Power Cord
6' 5"
Timer Settings
0-180 minutes (up to 3 hours), and continuous (HOLD)
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
TO PREVENT SERIOUS INJURY: Unplug the charger, disconnect any battery,
and allow charger to cool completely before assembling or making any adjustments to the charger.
Note:
For additional information regarding the parts listed in the following pages,
refer to
Parts List and Diagram
on page 11.
1. Place the Battery Charger/Starter on its side.
2. Use two Screws (10) to install the
Mounting Foot (5) to the front bottom of
the Charger/Starter. See Figure A.
3. Slide the Wheels (3) onto the ends of the Axle (4)
and slide an Axle Cap (6) onto each wheel. If
needed, tap on the Axle Caps with a rubber mallet.
NOTE:
Verify the Hub of each Wheel is facing in.
4. Set the Axle along the bottom of the Charger/
Starter and Align the Axle Brackets (7) with
the mounting holes. Once aligned, fasten
the Wheel Axle into place. See Figure A.
5. Stand up the Charger/Starter.
6. Remove the two top screws on each side of the
Charger/Starter and set the Handle against the
unit, aligning the mounting holes. See Figure B.
7. Use the Screws (9) to mount the Handle (2) on the
sides of the Charger/Starter (1). See Figure B.
Figure A: Foot and Wheel Installation
Axle (4)
Mounting
Foot (5)
Wheel
(3)
Axle Cap (6)
Axle
Bracket
(7)
Screws
(10)
Figure B: Handle Installation
Handle (2)
Screw (9)
Charger/
Starter (1)
SAFETY
OPERA
TION
MAINTENANCE
ASSEMBL
Y