CENNTRO METRO Series, Руководство пользователя

Страница: 17 / 36


Battery
Battery Pack
Battery pack in the vehicle provides energy require for the vehicle.
To maintain optimize battery pack performance, it is best to completely charged the battery regularly. A good practise is to
charge battery pack daily or after each use.
Attention:
Each battery pack has factory serial number. This information must be provided when replacing the battery pack
by authorized dealer.
Battery pack characteristics

A new battery pack will reach optimum performance after 20-30 charge and discharge cycles.

New battery pack must be completely charged before use.

Charge the battery pack each day or after each use

To maintain good battery performance, avoid letting battery pack to discharge to less than 20% SOC
On-board battery charger
On-board battery charger is located on the vehicle side panel.
Information of the battery pack(s) state of charge are display on the dashboard.
The vehicle should be charged at least once every 10 days even if it is not used.
Important note: Avoid parks the vehicle at places with extreme temperature.

Charging of battery pack
Warning! Must always use factory recommended charging cable (as well as length).
Use of non-recommended or extended cable may cause fire and damage the charger, which might result in serious harm or
fatal accident.
Warning!
When using electrical plug that are not conform to factory charging requirements, care must be taken to ensure the
charging cable has at least of 20A of current rating.
Warning! Charging the batteries at places without good air ventilation may result in fire. Do not smoke in the charging area.

Park vehicle on a flat surface. Ensure charging area has good air ventilation.

Ensure ignition key is at OFF position

Inspect the charging cable has no crack, loose or worn out. Do not use a worn-out charging cable.


First plug in the charging cable to the charging socket (located at the right side of vehicle panel), then plug in the
charging cable to wall outlet or charging station.

Use only 220 volts, alternating current (A/C), 16 A socket as shown in (2)

Connect the charging gun as shown in (1) to the vehicle socket as shown in (3)

Charging cable should be directly connect to wall charging point, do not share with other appliances to ensure it
is not overload

When disconnecting the charger, first unplug the charging cable from wall socket or charging station, then
disconnect charging cable from the vehicle.