Page 4
SKU 93028
For technical questions, please call 1-800-444-3353.
Operation
Measuring Disc (Drum Shoe) Pad Thickness
1.
Place the Caliper tips on both sides of the “pad backing
plate”, holding the flat side flush with the surface. Do
not apply pressure to the Caliper jaws. Press ZERO.
2.
Next, position the Caliper tips around both the backing
plate and pad with the flat tip flush on the backing plate,
and the point in any scoring on the pad. Check the dis-
play, and the reading shown will be the thickness of the
pad.
Note:
On the drum shoe, the flat tip must be held
flat across the pad.
Set-Up
1.
Install the battery as per the instructions on page 6.
2.
Press the On/Off button. Press the in/mm button to toggle between the desired unit
reading measurement. Wipe the tips of the Caliper clean and then close the Caliper
until the tips gently touch, and press the Zero button. The display will read, “0.000 or
0.00mm”. Do not force the Caliper closed when getting a reading, or the reading will be
wrong.
Inch Units
Indicator
FIGURE 1
REV 04/05
Note:
Before using for any application, follow the zeroing directions in “Set -Up” above.