Page 3
For technical questions, please call 1-888-866-5797.
Item 63603
7. People with pacemakers should consult their
physician(s) before use. Electromagnetic fields in
close proximity to heart pacemaker could cause
pacemaker interference or pacemaker failure. In
addition, people with pacemakers should:
• Avoid operating alone.
• Properly maintain and inspect
to avoid electrical shock.
8. The warnings, precautions, and instructions
discussed in this instruction manual cannot
cover all possible conditions and situations
that may occur. It must be understood by the
operator that common sense and caution are
factors which cannot be built into this product,
but must be supplied by the operator.
SAVE THESE
INSTRUCTIONS.
Operating Instructions
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section at the
beginning of this manual including
all text under subheadings therein
before set up or use of this product.
General Operating Instructions
1. Remove the protective tip from the Probe
(1). Be careful, the tip is sharp.
Note:
Before each use, first test the Circuit
Tester on a known, working 6V or 12V source
so you are sure it is in proper working order.
2. To test 6 volt or 12 volt fuses, wiring, or other
6V/12V circuitry, connect the Cord Clamp (11)
to one side/end of the fuse, wire, vehicle battery
post, etc. (either positive or negative pole).
3. Gently touch and hold the tip of the Probe (1) against
the other side/end of the object being tested.
4. If the Bulb (3) inside the Handle (2) illuminates,
this indicates there is electricity flowing through
the circuit. No illumination of the Bulb indicates no
electricity flowing through the circuit and that repair
or replacement of the object being tested is needed.
5. When finished using the Circuit Tester, replace
the protective tip and store the tool in a clean,
dry, safe location out or reach of children.
Maintenance and Servicing
Procedures not specifically explained
in this manual must be performed
only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ELECTRICAL
CONNECTIONS:
Disconnect the Circuit Tester from all power
sources before performing any inspection,
maintenance, or cleaning procedures.
Do not use damaged equipment.
If abnormal noise or vibration occurs, have
the problem corrected before further use.
Cleaning, Maintenance,
and Lubrication
1.
BEFORE EACH USE,
inspect the general condition
of the tool. Check for loose hardware, misalignment
or binding of parts, cracked or broken parts, damaged
electrical wiring, and any other condition that may
affect its safe operation.
Do not use damaged tools.
2.
AFTER USE,
wipe external surfaces
of the tool with clean cloth.
Changing the Bulb
1. To change the Bulb (3), remove the Cord
Clamp (11) from all power sources.
2. Unscrew the Tail Base (5) from the Handle
(2), and remove the Spring (4).
3. Unscrew the Bulb from the Spring and
replace with a new 12V/3W Bulb.
4. Replace the Spring and Bulb in the
Handle and screw in the Tail Base.
