Page 15
For technical questions, please call 1-888-866-5797.
Item 62142
Inspection and Maintenance
Procedures not specifically explained in this manual
must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ELECTRICAL SHOCK:
Make sure that the Scan Tool is unplugged from the vehicle
before performing any procedure in this section.
Inspection
1.
BEFORE EACH USE,
inspect
the general condition of the
Scan Tool. Check for:
• cracked or damaged Cable,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
Cleaning and Storage
1.
AFTER USE,
use a mild detergent
on a clean cloth to remove any oil,
grease or dirt from the Scan Tool,
especially on the buttons, being
careful to not put excessive
pressure on the Display Screen.
2. Do not use solvents on the Keyboard.
Do not soak the Keyboard, Use a mild
nonabrasive detergent and a soft cloth.
3. Store the Scan Tool, and accessories
away from sunlight in a dry, locked
area, out of the reach of children.
Troubleshooting
Problem
Possible Causes
Likely Solutions
Scan Tool doesn’t power up 1. OBD II Cable connector
not connected securely.
2. Vehicle’s DLC pins are
bent or broken.
3. Vehicle’s battery is bad.
1. Verify that Cable connector
is securely connected to
the vehicle’s DLC.
2. Check if the DLC pins are bent or
broken. If bent or broken, have a
certified technician repair the DLC.
3. Make sure vehicle’s battery
it providing at least 8V.
Vehicle Linking Error
1. Vehicle is not OBD
compliant.
2. Ignition is off.
3. Bad connection.
1. Verify that the vehicle is
OBD II compliant.
2. Verify that the ignition is ON.
3. Reset the tool by turning the
ignition off, waiting 10 seconds,
then turning the ignition back on.
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect power supply before service.
Brought to You by www.snapwhole.com
Brought to You by www.snapwhole.com
