SKU 03192
Page 3
9.
Stay alert
. Watch what you are doing, use common sense. Do not operate
any product when you are tired.
10.
Check for damaged parts
. Before using any product, any part that
appears damaged should be carefully checked to determine that it will
operate properly and perform its intended function. Any part that is damaged
should be properly repaired or replaced by a qualified technician. Do not use
the product if any switch does not turn On and Off properly.
11.
Replacement parts and accessories
. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty.
12.
Do not operate product if under the influence of alcohol or drugs
. Read
warning labels if taking prescription medicine to determine if your judgment
or reflexes are impaired while taking drugs. If there is any doubt, do not
operate the product.
Warning: People with pacemakers should consult with their physician(s) be-
fore using this product; operation of equipment in close proximity to a heart
pacemaker could cause interference or failure of the pacemaker.
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Operation
1.
Loading the Batteries: Unscrew the Battery Cap [A]. Insert two AAA
batteries, negative end first. Replace Cap tightly.
2.
Place Level on an even surface. Use the Foot [B] to support the Level by
turning it so that it is perpendicular to the Level. The On/Off Switch [C] and
the Level Vial [D] should be at the top of the Level.
3.
Turn the Adjusting Knob [E] until the bubble inside the Level Vial rests in the
middle of the Vial.
4.
Turn the On/Off Switch into the On position to project laser beam onto the
desired work piece. Do not look at the laser beam, or direct the laser beam
at the eyes of another person or animal.
5.
When finished, turn the Adjusting Knob back to the furthest “up” position, to
prevent the plastic casing of the Laser Level from deforming.
Unpacking
When unpacking, check to make sure all parts listed on Page 4 are included.
If any parts are missing or broken, please call Harbor Freight Tools at the num-
ber on the cover of this manual.
Brought to You by Augusta Flint
