Cembre ht51, Руководство по эксплуатации и обслуживанию

Страница: 4 / 8

3
subsequent dies re-opening, releasing the crimped connector.
2.4)
2.4) 2.4)
2.4) Dies
Dies Dies
Dies setting
setting setting
setting
-After completion of the work, release the oil pressure as directed in paragraph2.3
3.
3. 3.
3. WARNING
WARNING WARNING
WARNING
The tool is robust and requires very little daily maintenance.
Compliance with the following points , should help to maintain the optimum
performance of the tool.
3.1)
3.1) 3.1)
3.1) Accurate
Accurate Accurate
Accurate cleaning
cleaning cleaning
cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be cleaned with a clean cloth, taking care to remove
any residual, especially close to pivots and moveable parts.
3.2) 3.2) 3.2) 3.2) Storage Storage Storage Storage
When not in use, the tools should be stored and transported in the plastic case, to
prevent damage.
The iron case can also accommodate 10 die sets.
Plastic case size:46.5x30x10 mm.
3.3) 3.3) 3.3) 3.3) Head Head Head Head rotation rotation rotation rotation
For ease of operation, the tool head can rotate through 180 degree.
Warning:
Warning: Warning:
Warning: do
do do
do not
not not
not attempt
attempt attempt
attempt to
to to
to turn
turn turn
turn the
the the
the head
head head
head if
if if
if the
the the
the hydraulic
hydraulic hydraulic
hydraulic circuit
circuit circuit
circuit is
is is
is pressurized.
pressurized. pressurized.
pressurized.
4 4 4 4.... Maintenance Maintenance Maintenance Maintenance(refer (refer (refer (refer to to to to Fig.4.5) Fig.4.5) Fig.4.5) Fig.4.5)
Air in the hydraulic circuit may affect the performance of the tool; e.g. no lower die
advancement, slow advancement of the lower die; lower die pulsating.
In this case proceed as follows:
4.1) 4.1) 4.1) 4.1) To To To To purge purge purge purge air air air air bubbles bubbles bubbles bubbles from from from from hydraulic hydraulic hydraulic hydraulic circuit circuit circuit circuit
a- Hold tool upright in a vice with handles open
b- Remove bolt slide off the fixed handle to expose the oil reservoir, Recover spring
and spring cover.
c- Remove reservoir cap.