5
ENGLISH
– Unlock the moving handle (36) through the strap (01).
– Operate moveable handle to advance the ram and punch to achieve the required hole.
2.4) Retracting the punch
– Press the pressure release button (44), the ram will retract and the punch released.
– Remove the punch from the draw stud then carefully and completely remove punch scrap and
any residue from the die (Ref. to Fig. 2).
2.5) Rest setting
After completion of the work, press the pressure release lever (44) to release the oil pressure in the
tool
.
Fit the handle restraint (01).
3. USE OF NON ORIGINAL
Cembre
PUNCHING ACCESSORIES
To obtain the best operating results, the use of original
Cembre
punching accessories is recom-
mended; as an alternative, it is possible to use punching accessories made by other manufacturers
by requesting separately the specifi c adaptor. Check the compatibility of the accessories with the
characteristics of the
HT-FL75
tool (see page 28).
4. WARNING
The tool is robust, completely sealed and requires very little daily maintenance.
Compliance with the following points should help to maintain the optimum performance of the tool:
4.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic
device.
After each day's use, the tool must be wipped with
a clean cloth, taking care to remove any residual
particles, especially around moveable parts.
4.2) Storage
When not in use, the tool should be stored and
transported in the plastic case, to prevent damage.
The case is suitable for storing the tool, the accesso-
ries and up to 12 die sets and punches. Plastic case:
VAL-P28
, size 620x360x138 mm, (24.4x14.2x5.4
inches) weight 2,4 kg (5.3 lbs.).
