CELTIPOL CN-140, Техническое руководство

Страница: 26 / 45

26
CN-140 TECHNICAL MANUAL
03-2021
Translation of the original manual
15. SELECTING WORK TEMPERATURE.
Using the temperature controllers on each product and on the hose (EMKO ESM 4420), the
ideal temperature can be selected depending on the products to be used and the projection
work to be carried out. (The controllers are factory set with the factory temperature selected
according to customer requirements).
In order to select the required temperature, follow these steps:
1. Press PSET on the controller appearing on the PSET function screen.
2. With the keys
 
the temperature range is increased or decreased.
3. Once the ideal temperature has been set, press ASET to keep the selected value,
resetting the controllers screen to its initial status.
16. DAILY STOP SEQUENCE.
1. Close the stopcock taps on both products on the gun.
2. Activate the gun trigger two or three times to clean
9 .
3. Deactivate heating in the hose with the stop pushbutton 10 .
4. Deactivate heaters with the stop pushbutton.
5. Deactivate the cylinder with the stop pushbutton.
6. Open the stopcock taps on the products in the gut and pull the trigger several times
until the pressure in the products decreases below 30 bars (see output pressure gauges)
and check that the pump Piston rods are at their lowest position and fully insert them
inside the body of the pump in order to guarantee autolubrication.
7. Deactivate the pump with the stop pushbutton.
8. Disconnect the main switch.
9. Close the stopcock taps for products on the gun and pull the trigger 2 or 3 times.
10. Close the air stopcock on the gun.
11. Dismantle the side and front housings of the gun for cleaning. Lubricate with Celtipol
grease 11 .
12. Close the main compressed air valve on the machine.
13. Electrical disconnection of the machine.
9
Observe if there are
any losses in the
injectors by repeatedly
activating the trigger .
10
The hoses with hot
products should not be
bled.under no
circumstance.
11
Never dismantle the side blocks on the gun with
the product taps open since the gun may fill up with
foam and be a risk for the user.