Quick Set-up Guide [cont]
Properly assembled, the tube should appear
as pictured above.
11
Locate the finderscope. Remove the knurled
nuts on the threaded posts at the focuser end
of the telescope tube.
12
13
Loosen the set screw on the focuser so that it
does not obstruct the inner diameter of the
focuser. Remove the plastic cap covering the
end of the focuser.
14
Locate the 20mm eyepiece and remove the
plastic covers. Insert the chrome barrel of the
eyepiece into the focuser and secure in place
by tightening the set screw.
15
Remove the lens cap from the front of the
telescope. To observe, look through the
eyepiece as shown above.
16
For additional magnification, you can use the
included 3x barlow. Place the barlow in the
focuser in place of the eyepiece and tighten
set screw -- remove the cap from the barlow.
17
10
Insert the chrome barrel of the 20mm
eyepiece into the barlow and tighten the set
screw to secure in place.
Orient the finderscope so that the larger lens is
facing towards the front of the tube. Place
finderscope over the posts on the tube and
replace knurled nuts.
For detailed usage
information please
consult your owner’s
manual.
