Quick Set-up Guide [cont]
Secure slow motion control rod to telescope
tube by attaching the included bolt and
tightening.
11
Locate the finderscope. Remove the knurled
nuts on the threaded posts at the focuser end
of the telescope tube.
12
13
Loosen the set screw on the focuser so that it
does not obstruct the inner diameter of the
focuser. Remove the plastic cap covering the
end of the focuser.
14
Locate the diagonal and remove the plastic
covers. Insert the chrome barrel of the
diagonal into the focuser and secure in place
by tightening the set screw.
15
Insert the chrome barrel of the 20mm eyepiece
into the diagonal and tighten the set screw.
16
Remove the lens cap from the front of the
telescope. To observe, look through the
eyepiece as shown above.
17
18
Insert the chrome barrel of the 20mm eyepiece
into the barlow and tighten the set screw to
secure in place.
10
For additional magnification, you can use the
included 3x barlow. Place the barlow in the
diagonal in place of the eyepiece and tighten
set screw -- remove the cap from the barlow.
Orient the finderscope so that the lens window
is facing towards the front of the tube. Place
finderscope over the posts on the tube and
replace knurled nuts.
For detailed usage information please consult your
owner’s manual.
