Quick Set-up Guide [cont]
Hold the telescope tube assembly by the fork
arm and place the bottom of the base inside
the tripod mounting platform as shown.
11
Then thread the coupling screw into
the hole at the bottom of the fork arm base.
Tighten screw to secure the entire assembly.
12
When properly assembled your telescope
should look like this.
13
Place the computerized hand control in the
bracket on the accessory tray and connect the
hand control to the fork arm base as shown.
14
Attach the battery pack to the tripod by
hanging the strap from one of the wingnuts on
the tripod.
15
To attach the finderscope, loosen the silver
screw and slide finderscope into mounting
platform. The glass window should be facing
towards the front of the telescope.
16
Tighten silver screw to secure finderscope in
place.
17
18
Insert the chrome barrel of the 90º erect image
diagonal into the focuser and tighten the two
silver screws to secure in place.
19
Next loosen the silver screw at the top
of the 90º erect image diagonal and remove
the plastic cover.
20
Select the low power (25mm) eyepiece and
insert it as shown above. Tighten silver screw
to secure.
21
Remove tube lens cap to begin viewing.
22
While observing, tube should be positioned as
shown above.
23
A solar filter may be installed for viewing the
sun. Before use check to make sure there are
no pin holes in it. See inset. See owner’s
manual for complete instructions.
10
For detailed usage
information please
consult your manual.
Now you are ready to put in the 90º erect
image diagonal. First you must loosen the two
silver screws and then remove the plastic cap
from the focuser.
Coupling screw
