Personal Weather Station
with Wireless Remote Sensor
Model # 47001
Thank you for purchasing this Celestron
personal weather station. Please read the
instructions prior to using it and we hope you
will have many years of pleasure using it.
Set Up Power for the Receiver
Open the battery compartment door on the rear of the Receiver. Then insert
two AAA batteries (user supplied) with polarity as indicated in the battery
compartment. After installation, put the battery compartment door back on.
A low battery icon is displayed next to the outdoor humidity reading when
the batteries are low on power.
For optimum performance, please place the Receiver away from metal and
other sources of interference such as mobile phones, TVs, computers,
appliances, etc. If the Receiver stops showing the display or dims, replace
the batteries.
Set Up the Power & Make Settings for the Wireless Remote Sensor
Remove the small screw (center area of center image) from the rear door of the sensor with a small
screwdriver. Remove the cover (since it is sealed tight against the elements you may have to pry it
slightly with a screwdriver to get it off). Insert two AAA batteries (user supplied) as indicated in the
sensor (see right image). Set the switch to “1” (for Channel 1), push/toggle the button so readings will
be shown in “C” (Centigrade) or “F” (Fahrenheit). Then push the button “TEST” and hold it a couple
of seconds and it will transmit the RF signal from the sensor to the Receiver. The Sensor itself will
display the outside temperature and humidity (see left image). Replace the rear door of the sensor by
installing the small screw to hold it in place.
The Sensor can be mounted up to 100 feet (30 meters) in an open area from the Receiver to
communicate with it. The Sensor has a place on the rear of the unit to mount/hang it securely
(hanger
part on left of center image) to any surface that is secure or it can stand up (if in an area without wind,
etc.) by folding out the small stand (right part of center image).
ENGLISH
