CEL-MAR ADA-11040, Руководство пользователя, Страница: 10 / 16

4. ACTIVATION
If connection was made properly a green LED PWR on front panel of converter should lit after power on, if not check polarization of
connected power. When data is transmitted via the converter, RX, TX LED's on front panel and LED's on the module of RF interface
should blink.
This LED are described below:
LED Description
Power
PWR
Signalling of Power Supply.
RS485/RS422 interface
RX
Signalling of data receiving by ADA-11040 from RS485/RS422 port.
TX
Signalling of data transmitting from ADA-11040 via RS485/RS422 port.
5. CONFIGURATION
For correct work of ADA-11040 converter, is needed the configuration of settings wireless RF network and RS485/RS422 serial port.
5.1. OPERATION MODE
ADA-11040 converter can operates in two modes:
●
RUN,
●
configuration,
Those modes are setted by use of CONFIG jumper, located by SMA connector. To set mode, should remove terminal cover, marked
as CFG and put on or remove the jumper.
All available adjusting of the CONFIG jumper, are shown in table below.
Converter operation modes
CONFIG jumper Operation mode
OFF - open RUN
ON - close Device configuration
5.2. CONFIGURATION BY USING ADARF
5.2.1. ADARF INSTALLATION
The configuration of setting wireless RF network ADA-11040, can be made by the use of ADARF Software - selling with converter.
The installation is automatically after insert the CD (compact disc) to an optical drive. If the autorun doesn't start, should run the file
setup.exe located in main CD catalogue.
After installation the ADARF software is available in menu Start=>Programs=>CEL-MAR=>ADARf .
5.2.2. CONFIGURATION THE WIRELESS NETWORK SETTINGS
Set ADA-11040 converter in configuration mode, then connect the converter to PC according to point ' COMPUTER CONNECTION' ,
run ADARF software. Then follow the steps:
[1] select COM port.
[2] select baud rate of RS485/RS422 serial port.
10
ADA-11040