10
Frequently Asked Questions
•
Why there is raw material tank, a screen prompt is still lack of material?
- -
When the remaining raw materials of less than about 1L-cylinder machine prompts lack of material. If the business at this time is not over yet, please timely feed
- -
After remaining raw material shortage tips can make 10 copies of ice cream, then if there is no supplementary material, the machine will be forced to stop selling
•
Why hardness setting has not changed, today's ice cream produced relatively soft?
- -
The ratio of raw materials was confirmed, the ratio will affect the forming state
- -
When the number of produced small, soft ice cream may be easily changed, it is recommended to increase the hardness by promotion or improvement provided
•
Why raw material tank there, but put no ice cream?
- -
This phenomenon is called cold cylinder, i.e., too much air results in cooling the cylinder can not be extruded ice cream the stirring shaft. Probably because there is no time after raw
material addition, it may be rewound cutting the pot opening is blocked by ice cream
- -
Encountered not put ice cream, immediately press the "clean" button, and then pull up the expanded tube so that the raw material flowing into the cooling tank, the ice
cream until it can be released back into the extruded tube, to normal operation
•
Why raw material will flow out from the bottom of the tube in?
- -
When the intermediate shaft seal is not properly installed or missing equipment, from the bottom of the hose feed machine flows to alert the user, in case this case, the material
should be discharged as soon as possible and washing machine, according to page 4, FIG stirring shaft assembly reinstalling the orientation shown in ring
Troubleshooting
If an exception occurs, the screen will display fault Guide
- -
Please read the operating instructions displayed on the screen, according to one investigation process
- -
When troubleshooting or recurring, please add Shanghai Esse aftermarket micro letter for assistance:
