FIXING
a standard 600mm x 600mm modular ceiling
system.
(see Fig 1). Ensure sufficient space is left to allow the insertion of the grille frame
between heater and bracket. This option may require electrical connection prior to positioning. T
frame
Fitting in plasterboard type ceiling or bulkhead
The unit can be fixed in two ways depending on access available.(Note future access will be required for
servicing)
1) Locate
2) Locate the brackets to sit on top of the support frame (see Fig 2).Position the grille frame in the opening
and loosely fix with the 2 round headed screws provided. Place unit in ceiling from above and position within
grille frame. Secure brackets with woodscrews provided, tighten grille frame fixing screws.
The unit weighs 6kgs and as such can be mounted directly in a correctly installed modular ceiling. As an
added precaution additional ceiling supports can be added adjacent to the heater.
Locate the brackets to sit on top of the T bar frame. The ceiling tile is cut back as appropriate and finished
either with the grille frame or an additional T bar section.
Additional fixings may be required if the ceiling construction is not strong enough to take the heater weight.
Two 8mm holes are provided in the top of the heater to allow the fixing of drop rods (by others).
Fitting in modular ceiling.
Drop rod fixing
This unit is designed for installation in a plasterboard or similar ceiling where a free height above the surface
of the ceiling is at least 230mm. It is also sized to fit within
A 580mm x 130mm hole should be made in the ceiling and suitably framed.
Fix support brackets, with machine screws provided, to screwed inserts in side of unit
the brackets flush with the front of the heater. Place unit in ceiling from below and secure brackets
with woodscrews provided.
he grille
is then positioned and fixed with the 2 round headed screws provided.
The manufacturers reserve the right to change the specification at any time without prior notice EO&E
MAINTENANCE
Isolate the heater and remove any build up of dust etc. every 6 months. Check that the heater has not been
covered or the airflow restricted in any way.
Fig 1
Fig 2
WARRANTY
This product is guaranteed, in accordance with our Conditions of Sale, for a period of 12 months from date of
purchase. We will repair or replace, at our discretion, any part found to be defective. We cannot accept
responsibility for any consequential liability.
The warranty will be invalid if the heater has not been installed in accordance with these instructions.
This does not affect your statutory rights.
