8
Operating the Air Supply MV600-2
1. Ensure the power switch is in the off (o) position.
2. Plug the air supply into a 120VAC power outlet.
3. Connect the air supply hose to the REMUV™ Air Mat.
4. Turn the Power Switch at the top of the Air Supply MV600-2 to the on (
|
)
position (one power output with continuous flow).
5. Turn the Power Switch at the top of the Air Supply MV600-2 to the off (o)
position after use.
6. Disconnect the air supply hose from REMUV™ Air Mat.
7. Unplug the air supply power cord from wall outlet and store.
NOTE:
Duty Cycle: 30 sec ON, 1 min OFF, 5 cycles with 30 min rest period
Cleaning & Preventative Maintenance
Ensure the Air Supply MV600-2 is unplugged from power source before performing
any cleaning or preventative maintenance.
Between uses, clean the Air Supply MV600-2 by wiping it down with hospital-grade
disinfectant wipes. The manufacturer recommends the use of CaviWipes® or an
equivalent quaternary ammonium compound surface disinfectant wipe. If hospi-
tal-protocol approved, a bleach-based disinfectant may be used. For best results,
follow the wipe manufacturer’s recommended instructions for use. Do not spray
cleaners directly on the Air Supply MV600-2. Follow all Precautions and Intended
Use.
Prior to use, visually inspect the Air Supply MV600-2 to ensure the power cord is not
frayed or damaged and there is no visual damage that may render the air supply
unsafe or inoperable.
If any damage is found that may cause the air supply not to function as intended,
the air supply should be removed from use and returned to your authorized vendor
for repair.
WARNING: The Skin Integrity Pad or other hospital-approved skin protec-
tion barrier must be used between the patient and the REMUV™ Air Mat at
all times.
FIG. 8.1 Orientation of
Operator & Patient
during normal function of
the Air Supply MV600-2.
