Issue 4.00
5.0
INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
5.1
Using a 301-037 security tool (sold separately) loosen and remove the
security screw.
5.2
The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
5.3
Separate the cover assembly from the backplate assembly.
5.4
The backplate assembly may be installed on any standard backboard.
5.5
Run the inside station wire through the backplate assembly and terminate
on the RJ11C modular jack on the backplate, as depicted on the following
page. The CEECO-provided modular jack
must
be used, as it contains
required over-voltage protection.
5.6
The use of a gas tube station protector is recommended. The station
ground should not exceed 50 ohms.
5.7
Plug the modular line cord from the cover assembly into the RJ11C
terminal block.
5.8
Dress the line cable away from the security screw and install the cover
assembly by inserting the tabs into the slots on top of the backplate.
5.9
Secure the cover assembly by tightening the security screw.
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
C.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
D.
Use caution when installing or modifying telephone lines.
CEECO
Communication Equipment and Engineering Company
PROPRIETARY
5
