ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5
3.0
PROGRAMMING
NOTE:
It is recommended that you ground yourself to prevent ESD
damage to the PCB(s).
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
C.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface.
D.
Use caution when installing or modifying telephone lines.
1)
Connect
the Ceeco XFD Series Telephone
to the Telephone Line provided by your local
Telephone Company or to analog type PABX Station.
2)
Using another Telephone (Different Telephone Line or cell phone) equipped with a Touch Tone
Keypad,
call the CEECO XFD Series Telephone
.
3)
After 4 rings
of the CEECO Telephone,
answer it
by lifting the handset off hook and keep it that
way. Three tones should be heard indicating the phone is ready for remote input.
4)
With the other phone, enter # 2 3 3 2 6 *
. This is the factory default 5-digit pass code.
Instructions for changing the pass code appear below.
Two (2) beeps
will be heard indicating a
valid Pass Code entry. Five (5) beeps will only be heard when an error occurs and programming
was not accepted.
Two (2) beeps
will always be given to indicate each successful programming
entry below.
Enter # 9 7 * to clear all memory. It is not necessary to do this hereafter. Individual
programming options may be changed from time to time by entering only the necessary key
presses and there is no requirement to “re-program” everything each time.
If it is necessary to enter a PBX or other access digit, enter # 5 5 x * (where x = any number 0
thru 9 ). When a call is initiated, the phone will automatically dial this digit first.
If it is ever necessary to Disable the PBX/Access feature enter # 5 5 *.
If a pause is required between the PBX or Access number dialing and the auto-dial number,
enter # 5 8 x * (where x = # of seconds for the pause. 1 to 9 seconds maximum).
If it is required that the phone dial in Rotary Dial Mode enter # 5 7 1 * (Rotary 10pps).