ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5
5.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
5.1
Using a 301-037 security tool (sold separately), remove the security
screws.
5.2
The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
5.3
Separate the panel from the mounting box.
5.4
The mounting box is designed to be mounted flush with a flat vertical
surface. Mounting holes are provided on all sides and the back of the box.
5.5
Run the inside station wire through the mounting box and terminate the
Tip and Ring wires to the green and red wires of the RJ11C terminal
block, located inside the box.
5.6
The use of a gas tube station protector is recommended. The station
ground should not exceed 50 ohms.
5.7
Plug the modular line cord from the panel assembly into the RJ11C
terminal block.
5.8
Dress the line cable away from the mounting holes before installing the
panel onto the mounting box.
*****WARNING*****
A.
Never install telephone wiring during a lightning storm.
B.
Never touch uninsulated telephone wires or terminals unless
the telephone line has been disconnected from the network
interface.
C.
Never install telephone jacks in wet locations unless the jack
is specifically designed for wet locations.
D. Use caution when installing or modifying telephone lines.