ISSUE 4.0
5.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
5.1
The power supply is intended to run off of an 110v line and comes with a
3-prong grounding plug. The 110v outlet must be grounded, or a separate
ground wire should be run from the individual phone units to a suitable
ground. Plug the power supply into an 110v outlet and install the power
supply in the desired location. The selected location must be out of reach
for users.
*Grounding and installation must be in accordance with all
applicable local and national electrical and building codes.
5.2
Determine the desired mounting locations for the RJ11C modular
jack/interface units. Run the green and red (tip and ring) wires with the
modular jacks/interfaces to those locations. Mount the jacks/interfaces as
desired.
5.3
The SSP-350-X-145 is designed to fit into a standard double-gang,
masonry style, wall-mount box (provided) and is equipped with a modular
cord. Determine the desired routing path for the modular cords and make
the appropriate knock out holes on the mounting boxes. Install the
mounting boxes as desired.
5.4
Run the modular cords through the knock out holes in the mounting boxes.
Mount the telephone units, utilizing the security screws provided, to the
mounting boxes. The security tool, which is sold separately, must be used
for the security screws.
5.5
Plug the modular cords into the modular jacks/interfaces. The phone units
plugged into the same modular jack will allow talk paths to one another. If
more length is needed for the modular cords, a simple in-line coupler is
recommended. A section of modular-to-modular line cord can then be
used to bridge the desired distance. The coupler and line cord can be
purchased at a typical electronic supply store. Alternatively, the tip and
ring wire leads may be used.
5.6
The phone units must be plugged in with the power supply on for a few
minutes, before they will fully function.
***** WARNING *****
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack is specifically
designed for wet locations.
C.
Never touch uninsulated telephone wires or terminals unless the telephone
line has been disconnected at the network interface.
D.
Use caution when installing or modifying telephone lines.
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5