ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
5
5.0 INSTALLATION NOTES AND ASSEMBLY INSTRUCTIONS
5.1
Using a 301-064 security tool (sold separately) loosen and remove the security
screws. The security tool is for a standard 5/32" button head screw generally used
on the framework of the phone booths.
5.2
Carefully separate the faceplate assembly from the mounting box by gently
pulling the faceplate forward.
5.3
Determine and remove the desired knock out hole for running the telephone wire,
and mount the masonry box as needed.
5.4
Run the telephone wire into the box and terminate on the provided RJ11C
must
be used, as it contains required over-voltage protection circuitry.
5.5
The use of a gas tube or carbon station protector is recommended. The station
ground should not exceed 50 ohms.
5.6
Plug the modular line cord from the faceplate assembly into the RJ11C terminal
block.
5.7
Dress the line cable and modular jack away from the security screws and seat the
faceplate into the housing enclosure
.
5.8
Secure the faceplate assembly by tightening the security screws
.
WARNING
A.
Never install telephone wiring during a lightning storm.
B.
Never install telephone jacks in wet locations unless the jack is
specifically designed for wet locations.
C.
Never touch uninsulated telephone wires or terminals unless the
telephone line has been disconnected at the network interface
.
D.
Use caution when installing or modifying telephone lines
.