ISSUE 4.0
CEECO
Communication Equipment & Engineering Company
PROPRIETARY
7
PROGRAMMING CONTINUED
3.9
When you are
finished
programming,
press the “CALL & HANGUP”
button
to hang up the phone. Return the two plastic
mini-jumpers
to the
“OFF”
or outermost position, as depicted on the last page of this manual.
Secure the telephone assembly in the housing. The phone is now ready for
use.
3.10
Refer to the INSTALLATION NOTES section ahead for details regarding
the VoIP configuration setup prior to proceeding.
4.0
OPERATION
To receive a call, press the "EMER/CALL" button located on the front of the
phone, when the telephone rings. The LED (if provided) will illuminate red at this
time. In order to receive incoming calls the phone must have been programmed
with a “1” under Digit 2 in section 3.8 of this manual. When the call is answered,
a normal speakerphone conversation may take place. After the call is complete,
press the "EMER/CALL" button on the front of the panel again to hang up the
phone. If the user does not press the button on the front of the panel when he or
she is finished using the phone, then the phone will hang up after detecting a wink
(open switch interval) or the timer times out.
If the telephone has been mated with external call equipment, a call may also be
initiated by pressing the “EMER/CALL” button. The LED (if provided) will
illuminate red at this time. The external call equipment should direct the call as
intended and a normal speakerphone conversation may take place. After the call is
complete, press the "EMER/CALL" button on the front of the panel again to hang
up the phone. If the user does not press the button on the front of the panel when
he or she is finished using the phone, then the phone will hang up after detecting a
wink (open switch interval) or the timer times out.
5.0
RECOMMENDED TOOLS AND TEST EQUIPMENT
DTMF Test Set
Volt/Ohm Meter
CEECO Security Tool, 301-064