CEDES AG, Science Park | CH-7302 Landquart
Phone: +41 81 307 2323 | Fax: +41 81 307 2325 | [email protected] | www.cedes.com
TOF/Spot-car detection
Output A and B
NC (normally closed)
Logic selector connected to
GND (0 V) or not connected
NO (normally open)
Logic selector connected to U
SP
Contact
open
Contact
closed
Contact
open
Contact
closed
Select the desired output logic for your control unit with the output selector (gray wire)
1. Place an object at the desired threshold
distance.
Attention:
An offset of 150 mm is
required
2. Press the teach-in button on the rear side
of the sensor for more than 2 seconds
3. The status LED starts to blink for
approximately 30 seconds.
4. The threshold distance has been set
as soon as the LED stops blinking and
switches off.
5. Check functionality
Logic selector
Teach-in procedure (calibration)
LED status
Application recommendations
Information
Timing
Offset
150 mm
Start-up:
dimmed or
bright
blinking
blinking
≤ 30 s
Calibration
Sens
or
Pha
se
LED
B
ut
ton
1
2
3
≥ 2 s
Push
Release
LED status
Description
LED off
No power
LED dimmed red
No object detected
LED bright red
Object detected or test active
LED blinking
Distance setting active
Value
[
ms
]
Start-up time test input
< 200
Power-on time
1,000
Response time
≤ 60
Release time
≤ 60
Test response time
5
Test release time
≤ 60
Test time
> 60
Objects must interrupt the complete cross-section of the beam to be detected properly. If an object only partially interrupts the
beam’s cross-section, a correct distance evaluation cannot be guaranteed.
The enclosure rating of the sensor’s housing is IP65. Additional protection for heavy rain is strongly recommended. An
additional mounting bracket is available.
The sensor needs a background. If there is no background, it is possible that any object detected at a distance of 15 m or more
may be considered to be a car.
The complete TOF/Spot operating manual is downloadable from the CEDES website www.cedes.com.