cecotec Ready Warm 8200 Power Quartz Smart, Инструкция по эксплуатации

Страница: 34 / 64

34
ENGLISH
READY WARM 8200 POWER QUARTZ SMART
3. BEFORE USE
• Take the product out of the box.
• Remove all packaging materials. Keep the original box.
• Make sure all the components are included and in good conditions, otherwise, contact
immediately the official Technical Support Service of Cecotec.
• Check that all connections are completely secure and that the device is securely positioned
before using it.
4. PRODUCT ASSEMBLY
Wall mounting
• The heater housing must be at least 30 cm from the ceiling,
50 cm from side-walls and 1.80 m above the floor.
• This appliance must be fixed to a sturdy wall made from
cement or stone. Do not attach to wooden walls or walls
made from flammable materials. Use the wall bracket
provided; do not use any other supports or attachments.
• Drill 3 holes in the wall to match the wall bracket holes and
attach the wall bracket using the 3 screws provided. The
curved part of the device must be facing upwards, leaving
the device bracket holes at the bottom. The wall bracket
must be fixed horizontally.
• Hang the heater onto the wall bracket. The support element
fixed to the back of the heating unit must rest on the curved
part of the wall bracket; the screws must be placed into the round part of the keyhole-
shaped screw holes and gently pushed down until the device is firmly fixed.
• Check that the appliance is firmly fixed to the wall and in full horizontal position before
using.
Assembling the stand
• Place the bottom section of the stand (7) with the fastening plate onto the base (6) of the
stand, making sure the screw holes are aligned. Insert the 3 bolts through the holes and
tighten them firmly. Remove the cable holder and place the protective cover over the bolt
connections.
• Fix the mid-section of the stand (8) to the bottom-section (7) and fasten it into place with
one of the screws. Then, attach the top section stand (9) to the middle section in the same
way by using a screw.