FULL CRYSTAL SKY / ONYX /DIAMOND / SCARLET
FULL CRYSTAL SKY / ONYX /DIAMOND / SCARLET
31
30
ENGLISH
ENGLISH
Use the ball of your finger, not its tip.
You will hear a beep each time a touch is registered.
Even a thin film of water may make the controls difficult to operate.
Preparation
Place the pan on the induction hob before use.
Plug the appliance; the display will turn on and the appliance will emit a “beep”.
Press the power button to switch the device on. Press this button again to turn the appliance
off.
Once turned ON, the induction hob will turn automatically OFF after 1 minute without operation.
Img
. 3
( Page 14)
Mode selector
Press the mode selector button to select the desired mode, among the 5 available modes:
1. Manual mode: select the desired power level (from 0 to 10) with the increase and decrease
buttons
2. Keep warm
3. Soup
4. Rice
5. Coffee
Cooking time schedule (not available in the manual mode):
Once the desired mode has been selected, touch the cooking time schedule button to select
when you want the induction hob to start heating the pot/pan. The display will show 00:00
and start blinking.
Use the increasing button to set the time upwards (max. 59’).
Use the decreasing button to set the time downwards (max. 23h).
Once the desired number of hours and minutes has been selected, the display will stop blinking
automatically.
The induction hob will then start heating the pot/pan.
Timer (only available on manual and keep warm modes):
Once the desired mode has been selected, touch the cooking time schedule button to select
when you want the induction hob to start heating the pot/pan.
The display will show 00:00 and start blinking.
Use the increasing button to increase the time minute by minute and the decreasing button to
decrease it (max. 3h).
Once the desired time has been selected, the display will stop blinking automatically and the
induction hob will start heating the pot/pan immediately for as much time as selected, unless
turned off manually.
4. CLEANING AND MAINTENANCE
In order to clean the product, you must disconnect the power cord, wait until the glass plate
has cooled, then follow the instructions below:
Glass surface:
If the glass plate is very dirty, clean it using a damp, non-abrasive sponge or, for stubborn
stains, use an appropriate cleaning product, designed for use on glass hobs.
Cooking surface and control panel:
Use a damp, soft cloth to clean it. In case of any oil stains that are not easily removed, wipe
away the stains with a soft cloth rinsed in warm water and a little detergent and then, clean it
using a damp soft cloth.
Air inlet/outlet
Remove any dust with a cotton bud.
5. TROUBLESHOOTING
Abnormality codes: (Standby mode)
Problem
1. Receptacle missing or not suitable
2. Short circuit
3. Short circuit
4. Electric overload
5. Low electrical supply
6. The product does not heat
7. Overheating
Code
1. E0 or indicator blinks
2. E1 or indicator blinks
3. E2 or indicator blinks
4. E3 or indicator blinks
5. E4 or indicator blinks
6. E5 or indicator blinks
7. E6 or indicator blinks
Solution
1. Change the cookware.
