cecotec CONGA ROCKSTAR 1300 X-TREME, Инструкция по эксплуатации

Страница: 27 / 57

CONGA ROCKSTAR 1300 X-TREME 53 52
ENGLISH ENGLISH
Strange smell comes out the
device. The filters are dirty.
Wash the filter and dry it
before use.
Buy a new filter.
The device emits a plastic
smell. It is used for the first time. The plastic smell will
disappear after using it.
The rolling brush stops
working suddenly. Filter has been used for too
long.
Filter blocked. Replace the filter.
Clean the rolling brush.
For any further doubt or question, contact the official Technical Support Service of Cecotec.
7. TECHNICAL SPECIFICATIONS
Product: Conga RockStar 1300 X-Treme
Product reference: 05678
Battery: 25,9 V DC, 2500 mAh
Voltage and frequency: 100-240 V~, 50-60 Hz
Manufactured in China | Designed in Spain
(*) Technical specifications may change without prior notification to improve product quality.
8. DISPOSAL OF OLD ELECTRICAL APPLIANCES
This symbol indicates that, according to the applicable
regulations, the product and/or battery must be disposed
of separately from household waste. When this product
reaches the end of its shelf life, you should dispose of
the batteries/accumulators and take them to a collection
point designated by the local authorities.
Consumers must contact their local authorities or retailer
for information concerning the correct disposal of old
appliances and/or their batteries.
Compliance with the above guidelines will help to protect the environment.
9. TECHNICAL SUPPORT AND WARRANTY
Cecotec shall be liable to the end user or consumer for any lack of conformity that exists at the
How to remove the high-efficiency filter Fig. 17
- Pull the top tab of the main body and remove the high efficiency filter.
- Separate the filter from the cover by turning clockwise.
Cleaning the filters
- Clean with warm water.
- Allow them to dry completely before installing and using them again.
Jaliscazo brush
- Move the rotary brush release button with the finger toward the arrow and remove the
cover of one of the ends of the brush.
- Take one end of the brush out as shown on the image. Fig. 18
- It is important to clear and clean all the residues left in the brush’s rotary axis.
- After washing and drying all the parts, assemble it back in order to use the brush again.
6. TROUBLESHOOTING
Problem Possible cause Solution
The motor does not operate. No battery.
The vacuuming tube, brush,
battery, brush head or
handheld vacuum cleaner are
not assembled in place. Charge the vacuum cleaner.
Check that the components
and the handheld vacuum
cleaner are assembled
correctly.
Suction power level is very
low The dust tank is full.
Filters are dirty or blocked.
Air inlet of the vacuuming
tube or brush head are
blocked. Empty the dust tank.
Clean or replace the filter.
Clean the dirt attached to the
brush.
The charging indicator light
does not light up. The charger is not connected
to the mains.
The circuits inside the
charging base are damaged. Connect the charger to a
power socket.
Contact the official Technical
Support Service of Cecotec to
repair it.
The operating time after
charging has decreased. It has not been enough
charged.
Battery is damaged or too old. Charge the battery
completely.
Replace the battery.