BREEZECARE 4000 CONNECTED
BREEZECARE 4000 CONNECTED
43
42
ENGLISH
ENGLISH
Control panel does
not work
Hands are too wet when
operating control panel.
Keep hands dry while operating the
control panel.
Humidifier has
malfunctioned.
Stop using the device immediately
and contact the Technical Support
Service of Cecotec.
White dust
appears around the
humidifier
Water being used has a high
mineral content.
Use distilled water with the
humidifier. If distilled water is not
available, use purified or filtered
water. Remember to clean water
tank at least once a week.
Humidifier was not properly
cleaned after last use.
Clean humidifier.
Mist is coming out
from the base
Water tank is not positioned
correctly.
Turn off and unplug the humidifier,
then align the water tank cover with
its respective opening in the inner
chamber.
Mist fog coming out
from around nozzle
There are apertures between
the nozzle and water tank.
Reinstall the cover and check if the
nozzle is well plugged in the cover.
6. TECHNICAL SPECIFICATIONS
Product reference: 05613
Product: BreezeCare 4000 Connected
220-240V 50/60 Hz
Power: 110 W
Water tank capacity: 6L
7. DISPOSAL OF OLD ELECTRICAL APPLIANCES
The European directive 2012/19/EU on Waste Electrical and Electronic
Equipment (WEEE), specifies that old household electrical appliances must
not be disposed of with the normal unsorted municipal waste. Old
appliances must be collected separately, in order to optimize the recovery
and recycling of the materials they contain and reduce the impact on
human health and the environment.
The crossed out “wheeled bin” symbol on the product reminds you of your obligation to
dispose of the appliance correctly. If the product has a built-in battery or uses batteries, they
The ambient
humidity is too high
Humidifier is working in
Continuous mode.
Change the mode.
The humidity target is too
high.
Select a lower %RH target.
Room is not well-ventilated
Open a window to ensure proper
air flow for the humidifier or move
the humidifier to a better ventilated
room.
Excess water tank has
spilled while filling the water
tank or replacing the water
tank back onto the base.
Wipe off excess water from the
top and bottom of the base before
replacing the water tank.
There is
condensation in the
room
The room temperature is
too low.
Heat the room up.
The mist suddenly
stops coming out
Programmed timer period
has run out.
Turn humidifier on.
The water shortage indicator
is on.
Refill water tank.
The target humidity level is
reached.
Incorrect humidity
level is being
displayed.
Room is larger than the
effective range of the
humidifier.
Move the humidifier to a room
which is with suitable room size.
Moisture has built up inside
of the humidity sensor.
Turn off the humidifier and allow
the humidity sensor to completely
air dry before resuming use.
The nozzle is facing the
direction of the humidity
sensor.
Turn the nozzle so that it is facing
away from the humidity sensor.
Humidity sensor is broken of
defective.
Stop using the device immediately
and contact the Technical Support
Service of Cecotec.