cecotec 05341, Инструкция по эксплуатации

Страница: 15 / 56

ENGLISH
15 READY WARM 4000 SLIM FOLD
• Once the product has been properly assembled, remove the back panel.
• Introduce the gas cylinder in the back of the heater with the valve outlet facing outwards.
• Screw the correct regulator onto the gas cylinder valve clockwise. Screw it by hand only,
do not use a spanner.
LEAK TEST
This must be carried out in a well-ventilated area, free from any open flames or other sources
of ignition.
1.
With the regulator connected to the cylinder, turn on the gas cylinder valve 1 and 1/2 turns
anti-clockwise.
2. Brush and clean the connection between the regulator and the cylinder and from the
hose to the gas cylinder valve with a 50:50 solution of detergent and water.
3. The appearance of bubbles is an indication of a leak.
IF A LEAK IS DETECTED:
1.
Turn off the cylinder valve (clockwise).
2. Disconnect the regulator from the gas cylinder.
3. Take the gas cylinder to a cool, outdoor, well-ventilated area.
IF NO LEAK IS DETECTED:
1.
Slightly turn the cylinder to allow the regulator and hose to fit inside the product.
2. Place the back panel back in its place.
WARNINGS:
• Do not use the heater if a leak is found.
• Do not use a naked flame for leak testing.
• Do not operate any electrical equipment in the presence of a gas leak.
500 mm
500 mm
1000 mm
1000 mm