cecotec 02362, Инструкция по эксплуатации

Страница: 47 / 165

AGUAZERO 8000 FULL BUILT-IN
93 92
ENGLISH ENGLISH
9. TROUBLESHOOTING
Problem Possible causes Solutions
The dishwasher
does not turn on The fuse has blown or the
circuit breaker has tripped. Replace the fuse or restart the circuit
breaker.
Remove any other device sharing the
same circuit as the dishwasher.
The power supply is not on. Make sure the dishwasher is on and
door is properly closed.
Make sure that the power cord is
plugged into the socket properly.
Water pressure is too low. Check the water supply is connected
properly and it is not cut off.
The dishwasher door is not
properly closed. Make sure you properly close the door
and it clicks.
The water in the
dishwasher
is not drained The drain hose is
twisted or trapped. Check the drain hose.
Blocked filter. Check the filtering system.
Blocked kitchen sink. Check the kitchen sink to make sure
it is draining correctly. If the problem
is the kitchen sink is not draining, you
may need a plumber instead of the
Technical Service.
Foam in the
interior Unsuitable detergent. Use only detergent special for
dishwashers to prevent foam
formation. If there is foam forming,
open the dishwasher and let it
evaporate. Add a litre of cold water in
the bottom of the dishwasher.
Close the dishwasher door and select
any cycle. At the start, the dishwasher
will drain the water. Open the door
after the drainage to check the foam
has disappeared.
Repeat this process if necessary.
Spilled rinse aid. Always clean spilled rinse aid
immediately.
The interior is
stained You may have used detergent
with colouring. Make sure your detergent does not
contain colouring.
White film on the
interior surface Hard water. To clean the interior, use a soft
and damp cloth with detergent for
dishwasher and use rubber gloves.
Never use any cleaner other than
dishwasher detergent, as this may
cause foaming.
There are rust
stains on the
cutlery The affected items are not
dishwasher safe. Avoid washing articles which are not
dishwasher safe.
You did not run a programme
after adding salt to the
dishwasher. There were salt
remains in the washing cycle. Always run a wash programme with
no load after adding salt. Do not select
the Turbo+ function (if it is included
in this model) after adding salt to the
dishwasher.
The water softener cover is
loose. Check the water softener cover is
properly closed.
Knocking noise in
the dishwasher A spray arm is hitting an item
in the basket. Pause the programme and place the
items blocking the spray arm again.
Rattling noise in
the dishwasher The tableware is loose in the
dishwasher. Pause the programme and place the
items again.
Knocking noise
on water hoses This may be caused by
the installation or the pipe
section. It does not affect the dishwasher
operation. If you have any doubts,
contact a qualified plumber.