3.
Open the control box and disconnect the two pump wires from the
quick disconnect terminals.
4.
Loosen union fittings on pump and remove pump from urn.
5.
Replace pump and follow priming instruction.
NOTE: Pump and motor assembly is factory lubricated for the life of the
pump.
•
TIMER SOLID-STATE
Depress BREW button, hold for approximately 10 seconds, and then
release. If water flows from spray head when button is depressed and
stops flowing after button is released, then timer is faulty and should be
replaced. No water from spray head when button is depressed, indicates
BREW button is fault and must be replaced.
•
AGITATOR
OPERATION: The agitator pump circuit is programmed to operate when
the BREW button is pushed. Upon completion of the pump cycle, the
agitator pump will pump air through the manifold into the coffee gauge
glasses and into the coffee liner. The completed cycle will take
approximately 20 second. The agitator may be operated independently
of the brewing cycle, if the agitator button is depressed.
MAITENANCE: The air pump is capable of delivering enough air for
proper blending. However if enough agitation is not present, check
flexible tubing on top of gauge glasses and fittings, for possible air leaks.
If air pump does not operate on completion of brewing cycle or when
agitation button is depressed, replace air pump or solid state agitator
timer (black box).
•
BURNER MAITENANCE
The two main burners can be removed by first removing the base cover
panel and unfastening the burner ends. The main burners should be
cleaned both inside the venturi portion and on the outside using a soft
bristle brush. The main burners must be into the same position before
removal. Once a year, a qualified service agency should be contacted to
inspect the appliance for safe and proper operation.
IN
O
N
F
I L
O
P
T
F
O
PILOT ADJUSTMENT CAP
•
SAFETY PILOT:
Remove pilot adjustment cap on
the gas valve and turn adjustment
screw to provide properly sized
flame (3/4 inch long).
Replace the cap.
9