GB
26
Press
to confirm. The display will show:
By pressing the buttons
and
simultaneously, followed by button
to confirm, a complete
reset will be made.
Note:
If you no longer wish to perform the reset operation, wait 5 seconds without pressing any
button and the system will return to the settings menu.
Start button setting
According to the factory setting, the appliance distributes coffee only as long as the start button
(7 Fig. 1) is held down.
If this button is released during distribution of a shot, the motor stops, the system goes into pause
status and the display shows the time remaining to complete the shot and the message
“
WORKING
”. In addition, to highlight the fact that the distributed shot has not been completed, the
LED for the shot selected flashes. At this point, to complete the dose just press the start button
(7 Fig. 1) again with the filter-holder and keep it pressed until the shot is completed.
Instead, if you no longer wish to complete the dose, press one of the two shot buttons
or
to cancel the current shot and return the system to READY position.
However it is possible to change this function by programming the start button (7 Fig. 1) in
pulse
mode
. With this setting the distribution of coffee will begin with the simple pressing of the start
button (7 Fig. 1) and will end only at the end of the time set for the distribution of the required shot.
To
change the operating mode of the start button
, press the button
five times until this
screen is displayed:
Press
to confirm. The display will show:
Press the button
or
to set the function ON or OFF.
Press -
to delete
Use b -
pulse OFF
Set
start button
