4
5
EN
EN
SHL1200
Electromagnetic Shearlock - 1200kg
4
(x2)
1
2
(x8)
3
(x2)
1
2
(x8)
1
(x2)
1
2
(x8)
2
C - Surface mounting (Optional: KSHL Kit)
Fix the magnet on the door and
place the housings.
Measure and mark the center
lines to determine the magnet
position on the jamb and the
armature plate on the door
leaf frame. Then drill the fixing
screw holes to fix the screws
easily.
Important:
The
surface
housing can be mounted in
horizontal or in vertical in the
secure side.
Mount the brackets of the housing
on the jamb and on the door leaf.
Insert the cable and temporarily
fix the magnet and the armature
plate to the bracket of the
housing. Loosen the screws on
the side of the armature plate (1)
with the Allen key. Then adjust
the gap between the magnet and
the armature plate by adjusting
the top screws on the armature,
allow 2mm distance maximum.
Tighten the 2 screws on the side
of the armature plate (2) once
the test on the magnet has been
successfull.
+
_
NC
CO
MN
O
5] WIRING DIAGRAM
*Input voltage: 12V DC or 24V DC
The magnet can be powered in 12 VDC
or in 24V DC according to the jumper
settings.
Terminal block
+
Input voltage 12V or 24V DC*
-
Input voltage 12V or 24V DC*
T=NC
Normally closed contact
C=COM
Common
R=NO
Normally open contact
T
C
R
Insert a flat screwdriver to
adjust the Time Delay from 0
to 30 seconds.
Shorten
